Grace-digital GDI-BTAR122 User Manual download pdf (Page 4)

Front Panel

 Power: Press to turn unit on from standby. If there are no current Bluetooth

saved pairs the amplifier will automaticially go into pairing mode. The

amplifier will remember your previous settings, source selection, and

Blueooth pairs from your prior listeneing sessions.

 Bass: Press BASS+ to increase bass or BASS- to decrease bass. When the

LED light is on the center LED the bass is set to the neutral position.

 Treble: Press TREBLE + to increase treble or TREBLE- to decrease treble.

When the LED light is on the center LED the treble is set at the neutral

position.

 Balance: Press BALANCE R to center audio towards the right speaker or

BALANCE L to center audio towards the left speaker. When the LED light

is on the center LED the balance is perfectly centered.

 Bluetooth: Press once to select Bluetooth as your audio source. Press and

hold approximately 5 seconds to enter into Bluetooth pairing mode. The BT

light will start flashing when ready to pair with your Bluetooth device and

solid blue when the pairing is ready and music can be played. The amplifer

will show up as ‘Grace Digital’ on your device and no password is required.

While music is playing via Bluetooth, briefly pressing the BT button will

pause the song playing. Pressing it again will play the song.

 Aux in: Press to play music from your optional wired audio source

 Volume: Rotate to the right to raise the volume and left to lower the volume

1 2 3 4 5 6 7 8 9

No comments

Grace-digital GDI-BTAR122 User Manual Page 4